MarineSupplyStore.com Featuring The Best Selection In Marine Supplies Online

features and benefits:removes and installs power steering pump pulleys off most domestic vehiclesincludes the necessary adapters for servicing gm 3.1 l 3100 3400 and 3800 v6 engines gm 2.3l quad 4 four cylinder engines and ford 4.6l 5.4l and 5.8l modular v8 engines. fits pulley hubs with diameters of 1-1/8 in. 1-1/4 in. 1-5/16 in. and 1-3/8 in.includes quick disconnect tool for gm 1/2 3/4 and 1 ton pickups includes kdt3893 disconnect tool; kdt41561 bushing and screw set and the kdt41562 bushing and screw set

features and benefits:this puller removes steering wheels on most domestic and imported vehicles with or without telescoping steering columns. five sets of cap screws are included for various thread requirements. the forcing screw features a swivel end to protect steering shaft. cap screws included (pairs): 3/8-16 x 3-1/2; 5/16-18 x 3-1/2; 5/16-24 x 3-1/2; m8-1.25 x 90 mm; and 5/16-18 x 4 (sir). bar measures 4" x 1" x 1".

Wheel Nut Stainless Wheel Nut (5/8x18 Thread) Since 1859, Edson has been providing the most discriminating offshore enthusiasts with the highest quality boating and yachting equipment available anywhere. Now, in their 145th year, Edson has a strong foundation built on honesty and integrity along with a firm commitment to quality, value, and innovation. Melton International is proud to offer their impeccable range of products. Edson wheel nut adds a clean finished look to your PowerWheel. Constructed of highly polished 316 grade stainless.

features and benefits: removes the stabilizer link to replace struts on taurus sable and windstar easily removes the top steering stabilizer link so that strut can be replaced hardened socket fits the stem hex 8mm socketeasily removes the top steering stabilizer link so the strut can be replaced. place the holding tool over the 18mm steering link nut. the hardened socket fits the stem hex. turn the 8mm socket with a ratchet to remove.

features and benefits: prevents damage to steering shaft threads

Precise steering control for high-speed outboard boats SeaStar PRO outboard steering systems are the choice for high speed single-engine outboard boats, like bass, flats, combo race/ski and other performance boats with speeds above 65mph. Recommended for single non-power-assisted outboards up to 300hp. SeaStar PRO has steered the Bass Masters Classic since 1994. The easy-to-install Sea Star PRO kit is built using the same components used in factory boatbuilding. The kit includes a 2.0 PRO HH5770 helm, semi-universal front mount HC5345 cylinder, two quarts of oil and an installation guide. Kit can be used with jackplates (allow enough hose length for full steering motion and no interference during trim and tilt) and performance props. Compact helm has a 4 7/16" footprint and requires only a 3" cutout. Match the helm with Kevlar reinforced HO57XX hoses. Meets ABYC standards and NMMA requirements. Horsepower: Single engine 300hp; dual engine 600hp Speed: 60mph + Helm: 2.0 cu.ft. capacity Hose: Kevlar reinforced, 1500PSI Turns Lock-to-Lock: 4.25 Included equipment: Helm pump, cylinder, bleeder kit. Hoses sold separately. (Uses HO57XX series) Steering Wheel: Not included Steering Wheel Shaft: 3/4" tapered Warranty: Two years For PDF's of Teleflex documentation, including the BayStar/SeaStar Selection Guide and Installation Books, click here